|
Assembly Instructions
for Mosin Nagant Stock
|
|
Mosin
Nagant Monte Carlo Stock Instructions
|
Classic Hunting Design.
|
Fits 7.62x54R Rifles and Carbines.
Scope Mount also available (#MOI-0600)
|
***MAKE SURE YOUR RIFLE IS UNLOADED BEFORE STARTING***
STEP #1 Inspect chamber to be sure weapon is unloaded NOTE: "Finnish
Model heavy barrel" guns must have rear sights removed or barrel
channel relieved for sight. (See drawing at bottom showing Fig 1-A and
Fig 1-B)
|
|
Forearm Barrel Bands
|
STEP #2 Remove forearm barrel bands, upper wood, cleaning rod
and bayonet.
CAUTION: Bayonet is under spring pressure. Note: Some models have spring
steel bands on forearm.
|
Trigger Housing Screw
|
STEP #3 Remove bottom trigger housing screw.
STEP #4 Remove top screw located behind bolt. Note: Bolt must be uncocked
or removed for screw access. (To remove bolt, lift bolt handle, depress
trigger, pull bolt rearward.)
|
|
Reassemble
|
STEP #5 REASSEMBLY. Place trigger guard assembly in the Monte
Carlo stock. Place barreled action in Monte Carlo stock and start guard
screw. Tighten both screws and replace bolt assembly.
|
SPECIAL Modification Instructions
Rear Sight Clearance on the M-39 Mosin Nagant 7.62x54R Monte
Carlo Stock |
For the M-39 "Finnish Heavy Barrel"
the rear sight area in the stock must be relieved in order for the barrel
to seat completely. |
|
STEP #1 Place barreled action in stock for positioning. The rear
sight assembly on the M-39 rifle will not allow the stock to seat properly.
STEP #2 Material must be removed from the shaded areas
in order for the stock to seat properly. Cut a slot approx. 1/16" x 5/16"
wide x 3/8" deep on both front left and front right sides of the stock
as indicated by Figure 1-A. This may be accomplished using a "Dremel"
type tool with a cutter.
STEP #3 To obtain the correct rear clearance, simply file approximately
1/8" off the corner as indicated in Figure 1-B.
STEP #4 Your barreled action should now "drop" into the stock.
|
