Buttstock Pistol Grip Installation Instructions combatstocks

Rear Buttstock with Pistol Grip
Instructions

***MAKE SURE YOUR SHOTGUN IS UNLOADED BEFORE STARTING***

1) Remove the existing recoil pad from your shotgun stock by unscrewing the 2 Phillips head screws in the rear of the pad.

2) Using a long flat blade screwdriver to remove the stock bolt from the inside of the opening in the rear of the stock.

3) Select the adapter for your shotgun. The Mossberg and Maverick require no adapters. The Remington and Winchester adapters are shown left.

Winchester Adapter (smaller)
Remington Adapter (bigger)

Remington Short Spacer
(Cut this spacer with a hack saw to fit Norinco 98 series -see diagram left)

4) Select the rear spacer. Remington has 2 rear spacers for a long or short stock bolt. The longer bolt requires both spacers. The Winchester does not require a rear spacer.
(See diagram to cut Remington Short Spacer to fit Norinco 98 SeriesShotgun) NOTE: ALL SHOTGUNS USE THE PLATFORM.

To fit Norinco 98 Series, cut the Remington Short Spacer as shown, then follow Remington instructions.

5) Place the stock bolt through the spacer(s) and platform and install in the rear of the Pistol Grip Stock. With the stock bolt extending out of the front of the stock, place the front adapter over the bolt and against the stock. Place the Pistol Grip Stock up to the rear of the receiver and secure by tightening the original stock bolt.

6) Place the new recoil pad on the rear of the stock and secure with the 2 screws provided.